[. . . ] The manufacturer will not be held liable for any damages resulting from EN incorrect or improper installation. The minimum safety distance between the cooker top and the extractor hood is 650 mm. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. [. . . ] Mark a reference point as indicated at 116 mm from the vertical reference line and 320 mm above the horizontal reference line. Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. Adjust screws Vr to level the hood body When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125mm, the choice of which is left to the installer. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lowerexhaustflue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button EN When pressed for 2 seconds it starts the lighting system in "courtesy light" mode. Such function can be stopped by pressing the touch control for 2 seconds or just by pressing it shortly in order to return to the normal lighting mode. T1 When pressed the motor is stopped, regardless of the speed it is set to. Indicator lights Touch control unlit Touch control lit Lights off Lights on Motor on Motor off Touch control lit Second speed on Delay function on When pressed the motor is set to the first speed By a brief pressing the motor is set to the second Touch control lit speed. [. . . ] Release the touch control, touch controls L, T2 and F will light up normally. Within 3 seconds press the touch control F until the key itself flashes to confirm as follows: · Press the touch control F for at least 4 seconds, until the touch control T1 flashes. Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood. [. . . ]